Despatch P1400+ Temperature Controller Manuel d'utilisateur télécharger pdf (Page 9)

3

90mm

+0.5

–

0.0

(3.62” +.020 -.000)

2.3 Panel Cut-outs

The mounting panel must be rigid and may be up to 6.0mm (0.25 inches) thick. The cut-outs

required for the instruments are shown below.

Figure 2. Panel cut-out size

2.4 Panel-Mounting

CAUTION:

Ensure the inside of the panel is with the instruments operating temperature and that

there is adequate air flow to prevent overheating.

Figure 3. Panel-Mounting the instrument

CAUTION:

Do not remove the panel gasket, as this may result in inadequate clamping and sealing

of the instrument to the panel.

Hold firmly in position

(apply pressure to bezel only)

Mounting Panel

Instrument Housing

Ratchets

Gasket

Slide mounting clamp over the

instrument housing, towards rear face of

mounting panel, until the tongues

engage in ratchets and instrument is

clamped in position

.

90mm

+0.5

–

0.0

(3.62” +.020 -.000)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 109 110

Commentaires sur ces manuels

Pas de commentaire